Put up a solar mount frame is like build a strong stand, but it's on ground outside to hold sun panels that make power. The steps not hard; here main ones.
First step is mark and look at spots. Before build start, workers use tools to find where each post go on ground. This need big care, cause any small wrong in place will mess up whole line of sun panels put later.
The next step is put in piles. The base for sun power systems is often steel sticks – just long steel poles. Workers use pile hammers to push them right into ground at set spots. How deep steel sticks go down depends on how hard ground is; the goal is make sure each stick is strong enough to hold future weight of sun boards, plus outside pushes like wind and snow.
The third step is put up the hold thing. When all the pile bases are safe, workers start fit cross beams and slant braces onto the piles; these metal parts make a full hold frame. This frame is often set at an angle so the sun panels put on top can face the sun more good.
The fourth step is check and fix. Before put up the sun panels, workers look at flatness, angles and hold of all the support thing. If some parts not even, small changes can do at this time.
Finally, when the hold-up system is all done, the sun boards can be put on. The build of the hold-up thing's quality is real big important; only with good base and exact part put can the sun boards work safe for more than twenty-five years.
In sum, the making of solar mount systems have main steps: place spots, put piles, set frames and fix them. Whole thing need clear order of steps and do it right, so it's a key first part in solar power jobs.
